sliding wear
Description:
The DN 44 Dry & Lubricated Reciprocating Sliding & Fretting Machine incorporates a servo hydraulic actuator driven by a high frequency analogue controller, which derives its set points via a 16 bit control and data acquisition card from a standard PC running COMPEND 2000 software. Real time adaptive control features provided within the software allows high precision control of the actuator when working against highly non-linear loads. Sine, square, triangular and random waveforms may be programmed and, depending on the physical capabilities of the hydraulic system, oscillating frequencies up to 200 Hz may be controlled.
The machine is designed for fretting and fretting fatigue tests with nominal relative movement between contacting surfaces in the range 20 microns to 80 microns. It may also be used for sliding reciprocating tests at strokes up to 20 mm. Servo hydraulic actuation with piezo transducer friction force measurement and manual load control with strain gauge force transducer load measurement is incorporated.
Small Perturbation Signal Generator:
This optional additional signal generator and signal analysis system allows combined sliding motion with co-axial vibration to be generated. The standard servo amplifier incorporates a summing junction on the input stage with dual inputs. This means that with the addition of a second signal generator, two separate signal inputs, one low frequency and long stroke and one high frequency and short stroke, can be combined, thus producing reciprocating motion with superimposed vibration from a single servo hydraulic actuator.
Specification:
| Type of contact: | Ball/Flat
|
| Flat/Flat
|
| Line/Flat
|
| Type of Movement: | Sine, Square, Triangular and Random
|
| Load: | 5 to 1,000 N
|
| Friction Force: | +/-500 N Maximum
|
| Stroke - continuously variable: | 10 microns to 20 mm
|
| Frequency: | 0.1 Hz to 200 Hz
|
| Environment: | Dry or Lubricated
|
| Temperature: | Ambient to 600°C
|
| Super High Response Servo Valve: | 12 l/min
|
| Actuator with Hydrostatic Bearings:
|
| Dynamic Load: | 8.5 kN
|
| Static Load: | 5.5 kN
|
Small Perturbation Signal Generator:
| Type of Movement: | Sinusoidal sliding stroke with co-linear superimposed sinusoidal perturbation
|
| Sliding Motion: |
|
| Maximum Stroke: | 20 mm (Amplitude: 10 mm)
|
| Type of Movement: | Sinusoidal
|
| Frequency (FS): | 0 to 5 Hz
|
| Vibration Motion: |
|
| Stroke/Frequency: | 200 microns (Amplitude 100 microns) @ 0 to 100 Hz
|
| 100 microns (Amplitude 50 microns) @ 200 Hz
|
| Frequency (FP): | 0 - 200 Hz
|
| Control Requirements: | FP must be greater than FS x 20
|
Order As:
